Short Circuit Analysis on Distribution Network 20 kV Using Etap Software
DOI:
https://doi.org/10.29103/jreece.v1i2.5232Keywords:
short circuit fault, circuit breaker, ETAP (Electrical Transient Analysis Program),Abstract
In an electric power system, electricity is generated by the power plant and then channeled to a transmission line and then distributed to consumers, in the process of distributing electrical energy, the system does not always work in normal conditions, sometimes the system can experience disturbances such as one-phase, two-phase, and three-phase disturbances. This interference can disrupt the electrical system and can damage equipment if left unchecked, therefore it is necessary to install a protection device that can decide the interference so as not to damage other equipment when a disturbance occurs. Here the protection device used is a circuit breaker. In a fault condition, the circuit breaker must be able to separate the points of the fault so as not to damage other electrical equipment. In this case, to determine the capacity of the best protection device for the system, a short circuit fault simulation is performed. To simplify the calculation process here the author uses the help of ETAP software (Electrical Transient Analysis Program).
References
A. Hasibuan, S. Masri, and W. Othman, Effect of distributed generation installation on power loss using genetic algorithm method, in IOP Conference Series: Materials Science and Engineering, 2018, vol. 308, no. 1, p. 12034.
Hendriyadi, Perhitungan Arus Gangguan Hubung Singkat Pada Jaringan Distribusi Di Kota Pontianak, J. Tek. Elektro Univ. Tanjungpura, 2017.
F. Hermanto and T. Sukmadi, Analisis Jatuh Tegangan Dan Arus Hubung Singkat Pada Jaringan Tegangan Menengah Pt Rum, Transient, 2013.
A. Ridgway, Short circuit, New Sci., 2015, doi: 10.1016/S0262-4079(15)31468-8.
J. Schlabbach, Short-circuit currents. 2005.
C. Prévé, Protection of Electrical Networks. London, UK: ISTE, 2006.
A. R. A. El-Keib, Power system analysis: short-circuit load flow and harmonics, IEEE Power Eng. Rev., 2002, doi: 10.1109/mper.2002.1098043.
Badan Standardisasi Nasional, Persyaratan Umum Instalasi Listrik 2011 (PUIL 2011). 2011.
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:
(1) Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International License. that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
(2) Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
(3) Authors should of declare that agree for above agreement of copyright transfer agreement when they starting submission of manuscript on the open journal system account as sign that authors have aproved. This notice showed as official agreement of authors have agree above to Journal of Renewable Energy, Electrical, and Computer Engineering (JREECE) prior the publication.
