PROTOTIPE HAND-GEOMETRY SEBAGAI SISTEM VERIFIKASI

Authors

  • Rizal Tjut Adek Teknik Informatika Universitas Malikussaleh

DOI:

https://doi.org/10.29103/techsi.v4i1.102

Abstract

Geometric measurements of the human hand have been used for identity authentication in a number of commercial systems. In this project we have developed a prototype hand geometry-based verification system and analyzed it's performance. We have demonstrated the practical utility of this system by designing an application that uses hand geometry as opposed to password for restricting access to a web site. We present our preliminary verification results based on hand measurements of 50 individuals captured over a period of time.

References

. A.K. Jain, R. Bolle and S. Pankanti (Eds.), Biometrics: Personal Identification in Networked Society, Kluwer Academic

Publishers, 1998.

. R. P. Miller, Finger dimension comparison identification

system, US Patent No. 3576538, 1971.

. R. H. Ernst, Hand ID system, US Patent No. 3576537, 1971.

. I. H. Jacoby, A. J. Giordano, and W. H. Fioretti, Personnel

Identification Apparatus, US Patent No. 3648240, 1972.

. A Performance Evaluation of Biometric Identification Devices,

Technical Report SAND91-0276, UC-906, Sandia National

Laboratories, Albuquerque, NM and Livermore, CA, 1991.

. D. P. Sidlauskas, 3D hand profile identification apparatus, US

Patent No. 4736203, 1988.

Downloads

Published

2012-10-01

Issue

Vol. 4 No. 1 (2012)

Section

Articles

License

Authors retain copyright and grant the journal right of first publication and this work is licensed under a Creative Commons Attribution-ShareAlike 4.0 that allows others to share the work with an acknowledgement of the works authorship and initial publication in this journal.

All articles in this journal may be disseminated by listing valid sources and the title of the article should not be omitted. The content of the article is liable to the author.

Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.

Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.

In the dissemination of articles by the author must declare the TECHSI Journal as the first party to publish the article.